HP A6684A and A6685A HSC Fibre Channel Adapter Release Notes, December 2001

HP A6684A and A6685A HSC Fibre Channel Adapter Release Notes
Known Problems and Workarounds (10.20)
12
Known Problems and Workarounds (10.20)
There are no known 10.20 problems in this release.
Dependencies
The following dependencies are not A6684A or A6685A adapter problems, but you may
encounter them during installation or when booting the system. Therefore, they are listed as
dependencies.
You may see the following SD (Software Distributor) warnings and errors when you install the
software using swinstall. These messages are related only to SD. They do not apply to the
HSC Tachlite products. This problem will be fixed in a later version of SD.
• During the swinstall step, the following warnings are logged in the swagent.log file:
WARNING: The filesystems in the filesystem table will not be checked
against those currently mounted because the “mount_all_filesystems” option
is set to “false.”
You can ignore the message, or you can set the “mount_all_filesystems” option to “true”
and make sure that all the fstab entries are available.
WARNING: The Analysis Phase had warnings. See the above output for details.
This message is related to the previous warning. You can ignore this message.
The following messages are logged in the swremove.log file during swremove and
swinstall.
ERROR: Could not apply the software selection
“Obsolete.NCSNCK,l=/,r=B.11.00,a=HP-UX_B.11.00_32/64,v=HP,fa=HP-UX_B.11.00
_32/64”; it is not available from depot or root”
This problem is being fixed in a later version of SD. You can ignore this message.
ERROR: Cannot continue the “swremove” task
This message is related to the previous warning. You can ignore this message.
• The following problem is related to the HP-UX kernel boot loader:
If a host on the loop is booting, and another host on the same loop does an ioscan, the
booting host may experience a panic. The host will eventually come up when it tries to boot
again.