HP Fibre Channel Mass Storage Adapters Support Guide FibrChanl-01 (fcd) Driver

STM runs in three modes:
• Menu Mode
Use the mstm command to start STM in Menu Mode.
• X Windows environment
Use the xstm & command to start STM in X Windows.
• Command Line Mode
Use the cstm command to start STM in Command Line Mode.
Three tools are available in STM for Fibre Channel Mass Storage adapters:
• Information Tool
The Information Tool provides information about a Fibre Channel adapter without resetting
the adapter. The following is an example information log for a K-class system:
Log creation time: Tue Jun 6 14:12:23 2000
Hardware path: 8/12
Product ID: Fibre Channel Interface
Hardware Path: 8/12
Module Type: Type-A DMA I/O
Hardware Model: 0x15
Hardware Revision Number: 0
Software Revision Number: 0
Software Model Number: 0xa7
Software Option: 0x80
Hard Physical Address: 0xffb4c000
Slot Number: 3
IODC Revision: 0
World Wide Name: 1000080009F64883
Date Code: 3822
• Logtool Utility
The Logtool Utility extracts log errors and enables you to view them. This tool provides
information about a Fibre Channel adapter without resetting the adapter. The following is an
example utility log for a K-class system:
Log creation time: Mon Sep 11 17:47:07 2000
Device Path : 8/12
Product ID: Fibre Channel Interface
Product Qualifier: 15
Logger: td
Device Type: Interface
Device Qualifier: Fibre
-----------------------------------------------------------
Severity Level: Error
1Bolt Value: 88417
Error 17: The Fibre Channel Driver received a LINK DOWN interrupt.
Additional Information:
Frame Manager Status Register = 0x1
Received AL_PA Register = 0x2
Loss of Signal Counter = 3
Bad Received Character Count = 4
Loss of Synchronization Count = 5
Link Failure Count = 6
Received EOF Count = 9
HP Support Tools Manager 21