HP Fibre Channel Mass Storage Adapters Support Guide FibrChanl-02 (fclp) Driver HP-UX 11i v2 and 11i v3

E. Enter the swlist command to see if the Fibre Channel Mass Storage filesets have been installed.
For example, enter swlist -l fileset.
F. Does FC FILESET display? The file sets displayed depend on the Fibre Channel adapter product
you are using. An example of file set for the PCI Tachyon TL and XL2 adapters is:
FC-TACHYON-TL-FC-TL-KRN and FC-TACHYON-TL-RUN
An example file set for the AD299A single port adapter is:
FC-FCLP-KERN and FC-FCLP-RUN
An example file set for other Fibre Channel adapters is:
FCMassStorage.FCMS-KRN and FCMassStorage.FCMS-RUN
If the proper FILESET displays, and you still do not see the adapter, the adapter may have a
problem. Go to Flowchart 2: Fibre Channel Connections Test. If the file sets do not display,
proceed to I.
G. Update the system firmware. Then go back to number 1 on Flowchart 1: Configuration Test.
H. Device Displayed? If devices do not display, go to number 4 on Flowchart 2: Fibre Channel
Connections Test.
Fibre Channel Connections Test
Figure 2 Flowchart 2: Fibre Channel Connections Test
20 Troubleshooting and Maintenance