HP Fibre Channel Mass Storage Adapters Support Guide FibrChanl-02 (fclp) Driver HP-UX 11i v2 and 11i v3

Flowchart 3: Boot Test Procedures
The sections below provide additional detail on the procedures listed in Flowchart 3.
A. Is the system bootable over the Fibre Channel adapter? Only certain systems can boot over
the Fibre Channel adapter. If your system cannot do this, you must boot from a SCSI device.
B. Is the system firmware version adequate? Check the system firmware version on your system
for the minimum required date code for your adapter. If Yes, go to step D; if No, go to step
C.
C. Update firmware. Update the firmware to the appropriate level.
D. Is the minimum required Fibre Channel adapter ROM firmware installed? This step applies to
Fibre Channel adapters installed in HP/9000 and HP Integrity systems. If the minimum ROM
firmware version (or a later version) is installed, go to 4 on Flowchart 2: Fibre Channel
Connections Test. If not, go to step E.
E. Is the minimum required EFI version for the Fibre Channel adapter installed? This step applies
to Fibre Channel adapters installed in HP Integrity systems only. If the minimum EFI version
(or a later version) is installed, go to 4 on Flowchart 2: Fibre Channel Connections Test. If
not, go to step G.
Firmware Updates
This section explains the process for updating the firmware of your Fibre Channel host bus adapter.
Fibre Channel Host Bus Adapter Online Firmware Updates
The Fibre Channel host bus adapters that use the fclp driver can be updated while the system is
online, using the fcmsutil command. The rom_fw_update option to the fcmsutil command
updates the HBA's runtime firmware, and the efi_drv_update option of the fcmsutil command
updates the EFI driver.
Fibre Channel Host Bus Adapters Offline Driver and Firmware Updates
The Extensible Firmware Interface (EFI) is an Itanium-based preboot environment used to update
the EFI driver and firmware on the adapter. EFI can be used to update a single adapter port or
multiple ports, using the batch mode update.
Host bus adapters that use the fclp HP-UX driver use Emulex EFI driver menus for performing the
updates.
Preparing to Update
This procedure assumes that you have obtained a new EFI driver and/or adapter firmware from
HP, and have loaded it into an EFI filesystem called fs0. The efi_cp command can be used to
copy files from HP-UX into an EFI partition. It is important to make sure that the EFI filesystem is not
attached to the adapter you are about to update. It is often helpful to write down the EFI directory
and filename of the firmware file, because you will be required to enter the directory and filename
as part of the update.
Updating the Firmware
1. To view the Emulex driver handle information, type at the EFI shell prompt:
fs0:> drivers
A list of drivers is displayed.
2. Write down the driver handle associated with the Emulex SCSI Pass Thru Driver. The first
column, labelled DRV, lists the driver handles.
3. Enter the drvcfg -s <driver handle> command. For example, if the driver handle is
20 (your driver handle may be different):
fs0: drvcfg -s 20
22 Troubleshooting and Maintenance