HP Fibre Channel Mass Storage Adapters Support Guide FibrChanl-03 (fcoc) Driver HP-UX 11i v3

3 Troubleshooting and Maintenance
Introduction
Troubleshooting Fibre Channel problems can involve a variety of hardware and software
components. A problem affecting the system may originate in another part of the Fibre Channel
Mass Storage interconnect. If you cannot solve the problem on your own, contact your HP
representative.
Obtaining Card Information after Installation
Example of Card information after Installation
fcmsutil /dev/fcoc#
Vendor ID is = 0x19a2
Device ID is = 0x0704
PCI Sub-system Vendor ID is = 0x103c
PCI Sub-system ID is = 0x174a
Chip version = 2
Firmware and EFI Package version = 2.702.517.7
EFI Boot = ENABLED
Driver-Firmware Dump Available = NO
Driver-Firmware Dump Timestamp = N/A
Topology = PTTOPT_FABRIC
Link Speed = 10Gb
Allocated Link Bandwidth = 4000Mb
Local N_Port_id is = 0x010b01
Previous N_Port_id is = None
N_Port Node World Wide Name = 0x50060b0000c32619
N_Port Port World Wide Name = 0x50060b0000c32618
Switch Port World Wide Name = 0x200b00c0dd194252
Switch Node World Wide Name = 0x100000c0dd194252
Driver state = ONLINE
Hardware Path is = 0/0/0/9/0/0/2
Maximum Frame Size = 2048
TYPE = PFC
NPIV Supported = NO
Driver Version = @(#) FCOC: PCIe Fibre Channel driver (FibrChanl-03), B.11.31.1103
Jan 24 2011, FCOC_IFC (4,1)
This card is capable of running at bus speeds up to PCIe x4 link width. The actual link width is
displayed as the PCI Mode.
Example of Vital Product Data (VPD) after installation
V I T A L P R O D U C T D A T A
--------- ------------- -------
Product Description : "HP NC551m Converged Network Adapter"
Part number : "580153-001"
Part Serial number : "THC0431M75"
Engineering Date Code : "A5008"
Mfd. Date : "5043"
Misc. Information : "PW=14W; PCIE X8 GEN 2"
Firmware and EFI Package version : "2.702.517.7"
Event Monitoring Service
Event Monitoring Service (EMS) notifies you when an event occurs on the system.
A hardware event monitor monitors the hardware for unusual behavior (known as an event) and
sends a message to the EMS, which notifies you of the event and provides suggestions for correcting
the problem. This service is available for all of the Fibre Channel host bus adapters.
Introduction 11