HP Fibre Channel Mass Storage Adapters Support Guide FibrChanl-03 (fcoc) Driver HP-UX 11i v3

2 Fibre Channel Adapter Installation
Prerequisites
Before installing the adapter, follow these steps:
1. Verify compliance with supported configurations using the HP-UX Fibre Channel (fcd, fclp)
and FlexFabric FCoE (fcoc) Host Bus Adapter Support Matrix at: http://www.hp.com/go/
hpux-iocards-docs
2. Determine if the adapter is a Customer Replaceable Unit (CRU) using the HP-UX Fibre Channel
(fcd, fclp) and FlexFabric FCoE (fcoc) Host Bus Adapter Support Matrix. If the adapter is not
a CRU, contact your HP representative for installation assistance.
Field Replaceable Units (FRUs) must be installed or replaced by qualified Hewlett-Packard
service representatives only. CRUs can be installed or replaced by customers or qualified
Hewlett-Packard service representatives.
3. Check the following conditions:
• To verify that the/usr/bin, /usr/sbin, and /sbin directories are in the PATH, enter
the following command:
echo $PATH
• Verify that you have the following items:
◦ Grounding wrist strap
◦ Fibre Channel driver software media (included with the OS or application CD or
DVD)
◦ Fibre Channel host bus adapter with an optical port protector attached (not included
with all adapters)
• Verify that you have the following cabling items:
◦ Fiber optic cable terminated with a duplex LC connector.
◦ Cable map (optional)
Installing Driver Software
These instructions apply to software installation for the following configurations:
• HP NC551m, NC 553m and NC 1100E Dual Port Network Adapters
• NC 553M Dual Port 10Gb FlexFabric Converged Network Adapter
• CN1100E Dual Port 10GB Flexfabric Converged Network Adapter
Table 1 Fibre Channel Adapter Bundle and Product Names
DriverSoftware NameSoftware BundleOS VersionAdapter
fcocFC-FCOCFibrChanl-0311i v3 onlyHP NC 551m
fcocFC-FCOCFibrChanl-0311i v3 onlyCN1100E
fcocFC-FCOCFibrChanl-0311i v3 onlyNC553m
To install the software bundle, follow these steps:
1. Log in to the system as root.
2. Insert the CD or DVD into the drive.
3. Mount the CD using the following command:
mount /dev/dsk/<cd_rom_dev_file> /<tmp_mnt>
6 Fibre Channel Adapter Installation