HP Fibre Channel Mass Storage Adapters Support Guide FibrChanl-03 (fcoc) Driver HP-UX 11i v3

4. Run swinstall to install the software. Enter the following command:
/usr/sbin/swinstall
The Software Selection window and the Specify Source window open.
5. In the Specify Source window, change the Source Host Name if necessary. Enter the mount
point of the drive in the Source Depot Path field and click OK to return to the Software Selection
window.
Click Help to get more information.
6. Select the appropriate software bundle for your adapter.
7. Select Mark for Install from the Actions menu.
8. Select Install from the Actions menu. Installation begins and the Install Analysis window opens.
9. Click OK in the Install Analysis window to confirm that you want to install the software. The
Install window opens.
View the Install window to read processing data while the software installs. When the Status
field indicates Ready, the Confirmation window opens.
10. Click OK. A second Confirmation window opens.
11. Click OK again. The Install window opens.
12. Click Done. The Note window opens.
13. Click OK in the Note window to reboot. The user interface disappears and the system reboots.
14. Once the system comes back up, log in as root and open the following files to see any error
or warning messages that may have occurred during the installation:
/var/adm/sw/swagent.log
/var/adm/sw/swinstall.log
15. Install OnlineDiag, which is available at http://www.software.hp.com. OnlineDiag is also
available from the HP Support PLUS CD.
Installing Adapter Hardware
The Online Addition and Replacement feature, OL* for the HP-UX 11i v3 release, enables PCI host
bus adapters to be added or replaced without shutting down and rebooting the system, and without
adversely affecting other system components. The system hardware uses slot-specific power control,
combined with HP-UX operating system support, to enable these features.
NOTE: HP-UX 11i v3 does NOT support Online Replacement (OLR) with fcoc.
Confirm whether OL* is supported on the system in which you plan to install a Fibre Channel
adapter. See the HP-UX Fibre Channel (fcd, fclp) and FlexFabric FCoE (fcoc) Host Bus Adapter
Support Matrix at: http://www.hp.com/go/hpux-iocards-docs
IMPORTANT: Superdome systems are not intended to be maintained by customers. HP recommends
that Superdome systems only be opened by a qualified HP service engineer. Failure to observe
this recommendation can invalidate any support agreement or warranty to which you may be
entitled.
Installing the Fibre Channel Adapter
CAUTION: Observe all ESD safety precautions before attempting this procedure. Failure to follow
ESD safety precautions could result in damage to equipment.
NOTE: The optical port protector is used only to protect the adapter port when it is not in use.
Do not use the protector as a diagnostic tool.
Installing Adapter Hardware 7