HP Fibre Channel Mass Storage Adapters Support Guide FibrChanl-03 (fcoc) Driver HP-UX 11i v3

Install all driver software and dependent patches before you install the adapter. For more
information, see FibrChanl-03 (fcoc) Fibre Channel Mass Storage Driver for HP-UX 11i v3 Release
Notes available at: http://www.hp.com/go/hpux-iocards-docs .
NOTE: See the system documentation for information about how to safely shut down your system
and obtain access to expansion slots.
To install the Fibre Channel adapter, follow these steps:
1. Install all driver software and dependent patches.
2. Shut down the system.
3. Insert the card into the highest-performance PCIe slot available.
4. Attach fiber cabling to the adapter. All Fibre Channel host bus adapters that use the fcoc
driver use a cable terminated with an LC connector.
Attaching the Adapter to Other Fibre Channel Devices
To attach the adapter to other Fibre Channel devices, follow these steps:
1. Remove the Fibre Channel host bus adapter’s optical port protector (if included).
2. Attach a connector cable to the Fibre Channel host bus adapter.
a. Align the slotted plug with the keyed connector.
b. Push the connector in until you hear it click.
3. Attach the free end of the cable to a compatible Fibre Channel device.
4. Reconnect the power cord, if necessary, and power on the system.
Table 2-3 lists the Fibre Channel cables that you can use when connecting devices to Fibre Channel
host bus adapters.
Table 2 Cable Products
LC-LC
Fibre Channel Cable 2m LC-LC 50/125 Duplex221692-B21
Fibre Channel Cable 5m LC-LC 50/125 Duplex M/M221692-B22
Fibre Channel Cable 15m LC-LC 50/125 Duplex M/M221692-B23
Fibre Channel Cable 30m LC-LC 50/125 Duplex M/M221692-B26
Fibre Channel Cable 50m LC-LC 50/125 Duplex M/M221692-B27
LC-SC
Fibre Channel Cable 2m LC-SC 50/125 Duplex M/M221691-B21
Fibre Channel Cable 15m LC-SC 50/125 Duplex M/M221691-B23
SC-SC
Fibre Channel Cable 15m SC-SC 50/125 Duplex M/M234457-B23
NOTE: Be sure to use LC-LC or LC-SC cables for the Fibre Channel host bus adapters which use
the fcoc driver.
Verifying the Fibre Channel Adapter Installation
To verify that your Fibre Channel Adapter has been correctly installed, follow these steps:
1. Enter the following command:
ioscan -kfnN
8 Fibre Channel Adapter Installation