HP PCI Tachyon TL/TS/XL2 Fibre Channel Driver Release Notes, March 2010

Reinstalling the HP PCI Tachyon TL/TS/XL2 Fibre Channel Driver
To reinstall the HP Tachyon TL/TS/XL2 Fibre Channel driver on an HP-UX 11i v3 system, enter
the following command at the HP-UX prompt:
# swinstall -x autoreboot=true -x reinstall=true -x reinstall_files=true \ –s /tmp/<11.31_depot> FibrChanl-00
The following message is displayed:
Execution Phase succeeded
Verifying the HP PCI Tachyon XL2 Fibre Channel Driver Installation
To verify whether the FibrChanl-00 HP PCI Tachyon TL/TS/XL2 Fibre Channel driver is installed
successfully on your system, complete the following steps:
1. Enter the following command at the HP-UX prompt:
# swlist FibrChanl-00
Where:
FibrChanl-00 is the bundle name for the HP PCI Tachyon TL/TS/XL2 Fibre Channel
driver.
If the HP PCI Tachyon TL/TS/XL2 Fibre Channel driver is installed successfully on the
system, the following message is displayed:
# Initializing...# Contacting target "hostname"...## Target: hostname:/# FibrChanl-00
B.11.31.1003 FibreChannel; HW=A6795A,A5158AFibrChanl-00.FC-TACHYON-TL
B.11.31.1003 FibreChannel (TD) Driver
2. Enter the following command at the HP-UX prompt:
# swverify FibrChanl-00
The following message is displayed:
Verification Succeeded
NOTE: For information about errors encountered during the installation, removal, reinstallation,
and verification of the HP PCI Tachyon TL/TS/XL2 Fibre Channel driver, see the error log files
at /var/adm/sw.
Defect Fixes
Following defects are fixed in the current release.
Table 1-2 Defects Fixed on HP-UX 11i v3 OS During March 2010 Release
DescriptionDefect ID
When more than 500+ LUNs are connected to a HBA port, only the first 500
LUNs are identified by SNIA and the remaining LUNs are ignored.
This defect is fixed in the current release.
QXCR1000922032
Unable to capture dump with td driver.
This defect is fixed in the current release, and the td driver captures dump.
QXCR1000979380
8 HP PCI Tachyon TL/TS/XL2 Fibre Channel Driver Release Notes