HP PCI Tachyon TL/TS/XL2 Fibre Channel Driver Release Notes

is connected to the hub, switch, or device. The subsequent boot hangs unless you power
cycle the system.
Workaround: Disconnect the cable from the adapter before you perform the OLAR operations.
• Problem: During online replacement (OLR) of the A6795A adapter on the L2000 system,
the replacement may fail and the following error message may be displayed:
OLARD error: General error
Workaround: This problem is fixed in Processor Dependent Code (PDC) Version 41.38.
Defects Fixed in This Release
Table 1-2 lists the defects fixed in this release of the Fibre Channel PCI Tachyon TL/TS/XL2 driver.
Table 1-2 Defects Fixed in the HP-UX 11i v1 Operating System
DescriptionNumber
The command /opt/fcms/bin/fcmsutil /dev/td reports
negative value for Number of Assisted I/Os.
QXCR1000865946
Related Information
For more information about the HP PCI Tachyon TL/TS/XL2 Fibre Channel driver, see the
following documentation available at:
http://docs.hp.com/en/J2635-90041/J2635-90041.pdf
Support Guide This document provides a product overview, and discusses
additional features and regulatory information. It also describes
how to install, configure, troubleshoot, and maintain the driver.
Installation Guide This document describes how to install software and hardware for
specific HBAs.
Support Matrix This document discusses support matrix for Fibre Channel adapters,
supported hardware platforms, operating systems, driver bundle
versions, and minimum processor dependent code (PDC) or
firmware requirements.
White Paper The white papers suggest and describe ways to increase the
performance of Fibre Channel adapters.
Software Availability in Native Languages
The HP PCI Tachyon TL/TS/XL2 Fibre Channel driver software is available in the English language
only.
8 HP PCI Tachyon TL/TS/XL2 Fibre Channel Driver Release Notes