HP PCIe 16GB 1 port and 2 port Fibre Channel QLogic HBAs using HP-UX Installation Guide

3 Flash Instructions for updating the UEFI driver and
firmware
UEFI driver package contents
This list describes the files included in the UEFI driver package:
• HLDyyyyy.BIN - Combined binary file, which includes the binaries for BIOS, FCode, UEFI
driver, and ASIC firmware
• EFIUTIL.EFI or EFIUTILX64.EFI - UEFI Utility to update the UEFI driver, ASIC firmware, and
NVRAM
• QL26XX.DRV - Auxiliary driver file used for updating the adapter
• UPDATEIPF.NSH - UEFI script file used to update the adapter on a UEFI Itanium system
• EFICFG.PDF - Adapter Configuration and Diagnostic PDF
• EFIUTIL.PDF - Adapter EfiUtil Utility PDF
NOTE: All bin, EFI, and nsh files are required to update the adapter on a UEFI system.
UEFI driver installation
To update the UEFI driver and ASIC firmware on all adapters:
1. Unzip and copy the update kit files to the root level of a USB storage device.
NOTE: Do not change or rearrange the kit directories and/or files that were unzipped and
copied to the USB storage device.
2. Connect the USB device to the UEFI based system with the FC adapters.
3. Boot the system to the UEFI shell.
4. At the system's UEFI shell prompt, run the "map -b" command to find the USB device.
5. Locate the USB device and change to that device. For example, if the USB device is mapped
to fs9 after the map command, enter this command:
fs9:
The UEFI shell prompt should change:
fs9:\>
6. Run the UPDATEIPF.NSH script to update the UEFI driver and ASIC firmware. For example:
fs9:> UPDATEIPF.NSH
UPDATEIPF.NSH will call EFIUTIL.EFI to update all of the adapters.
Reboot the system to make the Driver/Firmware changes take effect.
UEFI driver package contents 11