HP PCIe 16GB 1 port and 2 port Fibre Channel QLogic HBAs using HP-UX Installation Guide

qualified Hewlett Packard service representatives only. CRUs can be installed or replaced by
customers or qualified HP service representatives.
3. Check these conditions:
• Verify that the /usr/bin, /usr/sbin, and /sbin directories are in the PATH by entering
this command:
echo $PATH
• Verify that you have these items:
Grounding wrist strap◦
◦ Fibre Channel driver software media (included with the OS or application CD)
◦ Fibre Channel host bus adapter with an optical port protector attached (not included
with all adapters)
• Verify that you have these cable items:
◦ Fiber optic cable terminated with a duplex LC connector
◦ Cable map (optional)
Important patches and updates
Review the FibrChanl-01 (fcd) Fibre Channel Mass Storage Driver for HP-UX Release Notes located
at http://www.hp.com/go/fibre-channel-HBA-docs for the latest patch and dependency
requirements. Install all driver software and dependency patches before you install the adapter.
NOTE: Patches are available from the website http://h20392.www2.hp.com/portal/swdepot/
index.do.
Installing driver software
NOTE: Use these instructions if the driver is provided on a CD-ROM. If the driver software is
downloaded, follow the instructions provided with that file. The driver software, FibrChanl-01, may
be downloaded from http://h20392.www2.hp.com/portal/swdepot/index.do. The FibrChnl-01
bundle is also provided on the Operating Environment media or Application Release media for
HP-UX 11iv3.
Install all driver software and dependency patches before you install the adapter. See the
FibrChanl-01 (fcd) Fibre Channel Mass Storage Driver Release Notes available at http://
www.hp.com/go/fibre-channel-HBA-docs for details.
Use this procedure to load the driver from a CD-ROM:
1. Log in to the system as root.
2. Insert the CD into the CD drive.
3. Mount the CD using this command:
mount /dev/dsk/cd_rom_dev_file/tmp_mnt
4. Run swinstall to install the software. Enter this command:
/usr/sbin/swinstall
The Software Selection window and the Specify Source window open.
5. In the Specify Source window, change the Source Host Name if necessary. Enter the mount
point of the drive in the Source Depot Path field and click OK to return to the Software Selection
window.
Click Help to get more information.
Important patches and updates 13