HP PCIe 16GB 1 port and 2 port Fibre Channel QLogic HBAs using HP-UX Installation Guide

fc 4 0/4/0/0/0/0 fcd CLAIMED INTERFACE HP SN1000Q 16Gb Dual Port PCIe Fibre Channel Adapter (FC Port 1)
fc 5 0/4/0/0/0/1 fcd CLAIMED INTERFACE HP SN1000Q 16Gb Dual Port PCIe Fibre Channel Adapter (FC Port 2)
The third column represents the hardware path of the slot that the adapter is installed. This
path will be different for each installed adapter port.
3. Observe whether the ioscan output reports this:
fc 0/7/0/0/0/0 UNCLAIMED UNKNOWN
If reported, HP-UX detected the adapter but the fcd driver is not recognized.
4. If the correct driver is installed and the adapter is not listed in the ioscan output, contact HP
for assistance.
Obtaining card information after installation
Review these reports for HBA card information after installation.
Example 1 Example of the ioscan -fnC fc command
# ioscan -fnC fc
Class I H/W Path Driver S/W State H/W Type Description
=====================================================================
fc 0 0/0/0/3/0/0/0 fcd CLAIMED INTERFACE HP SN1000Q 16Gb Dual Port PCIe Fibre Channel Adapter
(FC Port 1)
/dev/fcd0
fc 1 0/0/0/3/0/0/1 fcd CLAIMED INTERFACE HP SN1000Q 16Gb Dual Port PCIe Fibre Channel Adapter
(FC Port 2)
/dev/fcd1
# fcmsutil /dev/fcd0
Vendor ID is = 0x1077
Device ID is = 0x2031
PCI Sub-system Vendor ID is = 0x103C
PCI Sub-system ID is = 0x17E8
PCI Mode = PCI Express x8
ISP Code version = 6.7.2
ISP Chip version = 2
Topology = PTTOPT_FABRIC
Link Speed = 16Gb
Local N_Port_id is = 0x370500
Previous N_Port_id is = 0x370500
N_Port Node World Wide Name = 0x50014380231c4e55
N_Port Port World Wide Name = 0x50014380231c4e54
Switch Port World Wide Name = 0x20050027f8431740
Switch Node World Wide Name = 0x10000027f8431740
N_Port Symbolic Port Name = hilda_bf_fcd0
N_Port Symbolic Node Name = hilda_bf_HP-UX_B.11.31
Driver state = ONLINE
Hardware Path is = 0/0/0/3/0/0/0
Maximum Frame Size = 2048
Driver-Firmware Dump Available = NO
Driver-Firmware Dump Timestamp = N/A
TYPE = PFC
NPIV Supported = YES
Driver Version = @(#) fcd B.11.31.1309%_ic395 Jul 19 2013
This card is capable of running at bus speeds up to PCI-e x8 link width. The actual link width is
displayed as the PCI Mode.
16 Installing HBAs for HP-UX operating systems