HP-UX and Windows OS Installation Guide for HP PCIe 8Gb and 4Gb 2 Port Fibre Channel Emulex Mezzanine HBA

15. Install OnlineDiag, which is available at:
http://h20392.www2.hp.com/portal/swdepot/index.do
OnlineDiag is also available from the HP Support PLUS CD. Installation instructions are
available at:
http://docs.hp.com/en/diag/st/st_inst.htm
Installing Online Diag
Failure to properly complete the steps in this procedure may result in erratic system behavior
or system failure and may void the warranty. For assistance with this procedure, contact your
local HP Authorized Service Provider.
Install OnlineDiag, which is available at the following website:
http://h20392.www2.hp.com/portal/swdepot/index.do. OnlineDiag is also available from the HP
Support Plus CD for PA-RISC systems or the IPF CD for Itanium®-based systems. Installation
instructions are available at:
http://docs.hp.com/en/diag/st/st_inst.htm
Install all driver software and dependency patches before you install the adapter. See the
FibrChanl-02 (fclp) Fibre Channel mass storage driver release notes available at:
http://docs.hp.com/.
Verify the Fibre Channel adapter installation
1. To verify that the system recognizes the HBA, view the output listing from the following
command:
# ioscan -fnC fc
2. Verify the following drivers appear for each installed adapter. If all the drivers are listed,
proceed to the section titled verifying connectivity.
The ioscan -fnC fc output will display the following:
Class I H/W Path Driver S/W State H/W Type Description
====================================================================
fc 0 0/3/0/0/0/0 fclp CLAIMED INTERFACE HP 403621-B21 4Gb PCIe 2-port LPe1105 FC Mezzanine
Adapter
/dev/fclp0
fc 1 0/3/0/0/0/1 fclp CLAIMED INTERFACE HP 403621-B21 4Gb PCIe 2-port LPe1105 FC Mezzanine
Adapter
/dev/fclp1
fc 2 0/4/0/0/0/0 fclp CLAIMED INTERFACE HP 456972-B21 8Gb PCIe 2-port LPe1205 FC Mezzanine
Adapter
/dev/fclp2
fc 3 0/4/0/0/0/1 fclp CLAIMED INTERFACE HP 456972-B21 8Gb PCIe 2-port LPe1205 FC Mezzanine
Adapter
/dev/fclp3
The third column represents the hardware path of the slot that the adapter is installed. This
path will be different for each installed adapter port.
3. Observe whether the ioscan output reports the following:
fc 0/4/0/0/0/1 UNCLAIMED UNKNOWN
If reported, HP-UX detected the adapter but the fclp driver is not recognized.
4. If the correct driver is installed and the adapter is not listed in the ioscan output, contact
HP for assistance.
Obtaining card information after installation
Review the following reports for the HBA card information after installation.
Installing Online Diag 17