R211x-HP Flexfabric 11900 ACL and QoS Command Reference

87
Views
Layer 2 Ethernet interface view, Layer 3 Ethernet interface view
Predefined user roles
network-admin
Parameters
queue-id: Specifies a queue by its ID. A queue ID is a number in the range of 0 to 7 or a keyword in Table
32.
min band
width-value: Sets the minimum guaranteed bandwidth in kbps for a queue when the interface
is congested. The value range for the bandwidth-value argument is 8 to 1000000 for GE interfaces, 8
to 40000000 for 40-GE interfaces, 8 to 10000000 for 10-GE interfaces, and 8 to 40000000 for
40-GE interfaces.
Usage guidelines
You must use the qos wfq command to enable WFQ before you can configure this command on an
interface.
Examples
# Set the minimum guaranteed bandwidth to 100 kbps for queue 0 on Ten-GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface Ten-GigabitEthernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] qos wfq weight
[Sysname-Ten-GigabitEthernet1/0/1] qos bandwidth queue 0 min 100
Related commands
qos wfq
qos wfq
Use qos wfq to enable WFQ and specify the WFQ weight type on an interface.
Use undo qos wfq to disable WFQ and restore the default queuing algorithm on an interface.
Syntax
qos wfq { byte-count | weight }
undo qos wfq { byte-count | weight }
Default
An interface uses the SP queuing algorithm.
Views
Layer 2 Ethernet interface view, Layer 3 Ethernet interface view
Predefined user roles
network-admin
mdc-admin
Parameters
byte-count: Allocates bandwidth to queues in terms of bytes.
weight: Allocates bandwidth to queues in terms of packets.