R211x-HP Flexfabric 11900 ACL and QoS Configuration Guide

17
Table 2 Available match criteria
O
p
tion Descri
p
tion
acl [ ipv6 ] { acl-number | name
acl-name }
Matches an ACL.
The acl-number argument is in the range of 2000 to 3999 for an IPv4 ACL,
2000 to 3999 for an IPv6 ACL, and 4000 to 4999 for an Ethernet frame
header ACL.
The acl-name argument is a case-insensitive string of 1 to 63 characters,
which must start with an English letter, and to avoid confusion, it cannot be
all.
any Matches all packets.
control-plane protocol
protocol-name&<1-8>
Matches the control plane protocols.
The protocol-name&<1-8> argument is a list of system-defined control plane
protocols. &<1-8> indicates that you can enter up to eight system-defined
control plane protocols.
control-plane protocol-group
protocol-group-name
Matches the control plane protocol group.
The protocol-group-name argument can be critical, important, monitor, or
normal.
customer-dot1p
dot1p-value&<1-8>
Matches the 802.1p priority of the customer network.
The dot1p-value&<1-8> argument is a list of 802.1p priority values. An
802.1p priority ranges from 0 to 7. &<1-8> indicates that you can enter up
to eight 802.1p priority values.
customer-vlan-id vlan-id-list
Matches the customer VLAN IDs (CVLANs).
The vlan-id-list argument is in the format of vlan-id-list = { vlan-id | vlan-id1 to
vlan-id2 }&<1-10>, where the vlan-id, vlan-id1, and vlan-id2 arguments
represent the VLAN IDs and each range from 1 to 4094, vlan-id1 must be no
greater than vlan-id2, and &<1-10> indicates that you can specify up to 10
VLAN IDs or VLAN ID ranges.
destination-mac mac-address Matches a destination MAC address.
dscp dscp-value&<1-8>
Matches DSCP values.
The dscp-value&<1-8> argument is a list of DSCP values. A DSCP value
ranges from 0 to 63 or can be a keyword shown Table 3. &<1-8> indicates
that you can enter up to eight DSCP values.
ip-precedence
ip-precedence-value&<1-8>
Matches IP precedence.
The ip-precedence-value&<1-8> argument is a list of IP precedence values.
An IP precedence ranges from 0 to 7. &<1-8> indicates that you can enter
up to eight IP precedence values.
protocol protocol-name
Matches a protocol.
The protocol-name argument can be ARP, IP, or IPv6.
qos-local-id local-id-value
Matches a local QoS ID, which ranges from 1 to 4095. The switch supports
local QoS IDs in the range of 1 to 3999.
service-dot1p
dot1p-value&<1-8>
Matches the 802.1p priority of the service provider network.
The dot1p-value&<1-8> argument is a list of 802.1p priority values. An
802.1p priority ranges from 0 to 7. &<1-8> indicates that you can enter up
to eight 802.1p priority values.