R211x-HP Flexfabric 11900 ACL and QoS Configuration Guide

38
Ste
p
Command Remarks
6. Configure a traffic
policing action.
car cir committed-information-rate [ cbs
committed-burst-size [ ebs
excess-burst-size ] ] [ pir
peak-information-rate ] [ green action |
red action | yellow action ] *
By default, no traffic policing action is
configured.
The granularity of traffic policing is 8
kbps.
7. Return to system view.
quit N/A
8. Create a QoS policy
and enter QoS policy
view.
qos policy policy-name
By default, no QoS policy is
configured.
9. Associate the traffic
class with the traffic
behavior in the QoS
policy.
classifier classifier-name behavior
behavior-name
By default, a traffic class is not
associated with a traffic behavior.
10. Return to system view.
quit N/A
11. Apply the QoS policy.
• Applying the QoS policy to an
interface
• Applying the QoS policy to a VLAN
• Applying the QoS policy globally
Choose one of the application
destinations as needed.
By default, no QoS policy is applied.
12. (Optional.) Display
traffic policing
configuration.
display traffic behavior user-defined
[ behavior-name ]
Available in any view.
Configuring GTS
This feature is available on both Layer 2 and Layer 3 Ethernet interfaces. The term "interface" in this
section collectively refers to these two types of interfaces. You can use the port link-mode command to
configure an Ethernet port as a Layer 2 or Layer 3 interface (see Layer 2—LAN Switching Configuration
Guide).
The switch supports configuring queue-based GTS. In queue-based GTS, you set GTS parameters for
packets of a certain queue.
To configure GTS:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type interface-number N/A
3. Configure GTS for a
queue.
qos gts queue queue-number cir
committed-information-rate [ cbs
committed-burst-size ]
By default, GTS is not configured
on an interface.
The granularity of traffic shaping is
8 kbps.