R211x-HP Flexfabric 11900 ACL and QoS Configuration Guide

ManualsBrandsHP ManualsNetwork HardwareHP FlexFabric 11000 Switch Products

Configuring SP+WRR queuing

Configuration procedure

To configure SP+WRR queuing:

Ste

Command

Remarks

1. Enter system view.

system-view N/A

2. Enter interface view or port

group view.

interface interface-type

interface-number

N/A

3. Enable byte-count or

packet-based WRR queuing.

qos wrr { byte-count |

weight }

The default queuing algorithm on an interface

is SP queuing.

4. Assign a queue to the SP

queue scheduling group.

qos wrr queue-id group

By default, all the queues of a WRR-enabled

port are in WRR group 1.

5. Assign a queue to a WRR

group, and configure the

scheduling weight for the

queue.

qos wrr queue-id group

{ 1 | 2 } { weight |

byte-count }

schedule-value

Select weight or byte-count according to the

WRR type (byte-count or packet-based) you

have enabled.

By default, all queues are in WRR group 1,

and the weights of queues 0 through 7 are 1,

2, 3, 4, 5, 6, 7, and 8, respectively.

Configuration example

1. Network requirements

{ Configure SP+WRR queuing on Ten-GigabitEthernet 1/0/1, and use byte-count WRR.

{ Assign queues 0, 1, 2, and 3 on Ten-GigabitEthernet 1/0/1 to the SP group.

{ Assign queues 4 and 5 on Ten-GigabitEthernet 1/0/1 to WRR group 1, with the weights being

1 and 2, respectively, and assign queues 6 and 7 to WRR group 2, with the weights being 1

and 3, respectively.

2. Configuration procedure

# Enter system view.

<Sysname> system-view

# Configure SP+WRR queuing on Ten-GigabitEthernet1/0/1.

[Sysname] interface Ten-GigabitEthernet 1/0/1

[Sysname-Ten-GigabitEthernet1/0/1] qos wrr byte-count

[Sysname-Ten-GigabitEthernet1/0/1] qos wrr 0 group sp

[Sysname-Ten-GigabitEthernet1/0/1] qos wrr 1 group sp

[Sysname-Ten-GigabitEthernet1/0/1] qos wrr 2 group sp

[Sysname-Ten-GigabitEthernet1/0/1] qos wrr 3 group sp

[Sysname-Ten-GigabitEthernet1/0/1] qos wrr 4 group 1 byte-count 1

[Sysname-Ten-GigabitEthernet1/0/1] qos wrr 5 group 1 byte-count 2

[Sysname-Ten-GigabitEthernet1/0/1] qos wrr 6 group 2 byte-count 1

[Sysname-Ten-GigabitEthernet1/0/1] qos wrr 7 group 2 byte-count 3