R211x-HP Flexfabric 11900 ACL and QoS Configuration Guide

[Device] traffic classifier classifier_fserver

[Device-classifier-classifier_fserver] if-match acl 3002

[Device-classifier-classifier_fserver] quit

# Create a traffic behavior named behavior_dbserver, and configure the action of setting the local

precedence value to 4.

[Device] traffic behavior behavior_dbserver

[Device-behavior-behavior_dbserver] remark local-precedence 4

[Device-behavior-behavior_dbserver] quit

# Create a traffic behavior named behavior_mserver, and configure the action of setting the local

precedence value to 3.

[Device] traffic behavior behavior_mserver

[Device-behavior-behavior_mserver] remark local-precedence 3

[Device-behavior-behavior_mserver] quit

# Create a traffic behavior named behavior_fserver, and configure the action of setting the local

precedence value to 2.

[Device] traffic behavior behavior_fserver

[Device-behavior-behavior_fserver] remark local-precedence 2

[Device-behavior-behavior_fserver] quit

# Create a QoS policy named policy_server, and associate traffic classes with traffic behaviors in the

QoS policy.

[Device] qos policy policy_server

[Device-qospolicy-policy_server] classifier classifier_dbserver behavior

behavior_dbserver

[Device-qospolicy-policy_server] classifier classifier_mserver behavior

behavior_mserver

[Device-qospolicy-policy_server] classifier classifier_fserver behavior

behavior_fserver

[Device-qospolicy-policy_server] quit

# Apply the QoS policy named policy_server to the incoming traffic of Ten-GigabitEthernet 1/0/1.

[Device] interface Ten-GigabitEthernet 1/0/1

[Device-Ten-GigabitEthernet1/0/1] qos apply policy policy_server inbound

[Device-Ten-GigabitEthernet1/0/1] quit

Local QoS ID marking configuration example

Local QoS ID marking allows you to mark the same local QoS ID for packets of multiple classes and

configure a new class to match the local QoS ID to group these packets into the new class. With this

feature, you can perform QoS actions for the old classes respectively and perform other QoS actions for

the new class. In this way, you can perform layers of QoS actions for the specific packets.

Network requirements

As shown in Figure 20, configure local QoS ID marking and traffic policing to limit the outgoing traffic

of the administration department and the R&D department to 102400 kbps, respectively, and limit the

outgoing traffic of the marketing department (containing two sub-departments) to 204800 kbps.