R211x-HP Flexfabric 11900 EVB Command Reference

14
Examples
# Set the IPv4 address of the default VSI manager to 192.168.100.20.
<Sysname> system-view
[Sysname] evb default-manager ip 192.168.100.20
evb enable
Use evb enable to enable EVB on an interface.
Use undo evb enable to disable EVB on an interface.
Syntax
evb enable
undo evb enable
Default
EVB is disabled on an interface.
Views
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
Predefined user roles
network-admin
mdc-admin
Usage guidelines
Do not enable EVB on a member port of an aggregation group, or add a member port with EVB enabled
into an aggregation group. Otherwise, an error message appears.
Restore all default settings for an interface before enabling EVB on the interface.
A default S-channel is created on an interface after EVB is enabled on the interface, with both SCID and
SVID as 1. After an S-channel is created, an S-channel interface or S-channel aggregate interface is
created and operates in access mode.
Do not configure VLAN settings or enable any other Layer 2 protocol on an interface with EVB enabled.
Delete all non-default S-channels on an interface before disabling EVB on the interface. The default
S-channel is deleted after EVB is disabled.
Do not enable both EVB and QinQ on the same interface.
Do not enable both EVB and VLAN mapping, or both EVB and TRILL on the same interface.
Examples
# Enable EVB on Ten-GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] evb enable
# Enable EVB on Bridge-Aggregation 1.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] evb enable