R211x-HP Flexfabric 11900 EVB Command Reference

21
mdc-admin
Parameters
vsi-local-id: Specifies a VSI local ID in the range of 0 to 1023.
association: Specifies the association property. On a VSI with the association property, all filters
immediately take effect.
pre-association: Specifies the pre-association property. On a VSI with the pre-association property,
VLAN filters take effect, but <VLAN, MAC> filters are not effective.
Usage guidelines
A VSI is created on an S-channel interface through this command, and it is a subinterface of the
S-channel interface. A VSI aggregate interface is created on an S-channel aggregate interface, and it is
a subinterface of the S-channel aggregate interface. Removing an S-channel also removes all its VSIs and
VSI aggregate interfaces.
A VSI or VSI aggregate interface is usually created or deleted by a VSI manager. You can also manually
create or delete a VSI, or modify its pre-association or association property by executing this command.
When you change association to pre-association for a VSI or VSI aggregate interface, if MAC address
information is contained in the traffic sent by a VM, the MAC address is removed from the drive on the
EVB bridge, and the traffic from the VM cannot be forwarded. When you change pre-association to
association for a VSI, the EVB bridge sets the VM's MAC address.
After creating a VSI or VSI aggregate interface, you can enter VSI view or VSI aggregate interface view
by executing the interface command.
Examples
# Create a VSI on S-Channel 1/0/1:10, with VSI local ID 1 and the association property.
<Sysname> system-view
[Sysname] interface s-channel 1/0/1:10
[Sysname-S-Channel1/0/1:10] evb vsi 1 association
# Create a VSI aggregate interface on Schannel-Aggregation 1:10, with VSI local ID 1 and the
association property.
<Sysname> system-view
[Sysname] interface schannel-aggregation 1:10
[Sysname–Schannel-Aggregation1:10] evb vsi 1 association
Related commands
• evb s-channel
• evb vsi filter
• interface
evb vsi active
Use evb vsi active to activate a VSI or VSI aggregate interface.
Use undo evb vsi active to deactivate a VSI or VSI aggregate interface.
Syntax
evb vsi active
undo evb vsi active