R211x-HP Flexfabric 11900 FCoE Configuration Guide

# Enable interface Ten-GigabitEthernet 1/0/1 to automatically negotiate with its peer to decide

whether to enable PFC, enable PFC for 802.1p priority 3, and configure Ten-GigabitEthernet

1/0/1 to trust the 802.1p priority carried in packets.

[SwitchB-Ten-GigabitEthernet1/0/1] priority-flow-control auto

[SwitchB-Ten-GigabitEthernet1/0/1] priority-flow-control no-drop dot1p 3

[SwitchB-Ten-GigabitEthernet1/0/1] qos trust dot1p

[SwitchB-Ten-GigabitEthernet1/0/1] quit

# Create interface VFC 1, and configure it to operate in F mode.

[SwitchB] interface vfc 1

[SwitchB-Vfc1] fc mode f

# Bind interface VFC 1 to interface Ten-GigabitEthernet 1/0/1, and assign it to VSAN 1 as a trunk

port.

[SwitchB-Vfc1] bind interface ten-gigabitethernet 1/0/1

[SwitchB-Vfc1] port trunk vsan 1

[SwitchB-Vfc1] quit

# Assign interface Ten-GigabitEthernet 1/0/1 to VLAN 10 as a trunk port.

[SwitchB] interface ten-gigabitethernet 1/0/1

[SwitchB-Ten-GigabitEthernet1/0/1] port link-type trunk

[SwitchB-Ten-GigabitEthernet1/0/1] port trunk permit vlan 10

[SwitchB-Ten-GigabitEthernet1/0/1] quit

# Create interface VFC 2, and configure it to operate in E mode.

[SwitchB] interface vfc 2

[SwitchB-Vfc2] fc mode e

# Bind interface VFC 2 to interface Ten-GigabitEthernet 1/0/2, and assign it to VSAN 1 as a trunk

port.

[SwitchB-Vfc2] bind interface ten-gigabitethernet 1/0/2

[SwitchB-Vfc2] port trunk vsan 1

[SwitchB-Vfc2] quit

# Assign interface Ten-GigabitEthernet 1/0/2 to VLAN 10 as a trunk port.

[SwitchB] interface ten-gigabitethernet 1/0/2

[SwitchB-Ten-GigabitEthernet1/0/2] port link-type trunk

[SwitchB-Ten-GigabitEthernet1/0/2] port trunk permit vlan 10

[SwitchB-Ten-GigabitEthernet1/0/2] quit

# Enable FCoE for VLAN 10 and map VLAN 10 to VSAN 1.

[SwitchB] vlan 10

[SwitchB-vlan10] fcoe enable vsan 1

[SwitchB-vlan10] quit

# Permit the members in the default zone in VSAN 1 to access each other.

[SwitchB] vsan 1

[SwitchB-vsan1] zone default-zone permit

[SwitchB-vsan1] quit

Verifying the configuration

1. Verify the configuration on Switch A.

[SwitchA] display fc domain vsan 1