R211x-HP Flexfabric 11900 FCoE Configuration Guide

# Create interface VFC 3, and configure it to operate in F mode.

[SwitchC] interface vfc 3

[SwitchC-Vfc3] fc mode f

# Bind interface VFC 3 to interface Ten-GigabitEthernet 1/0/3, and assign it to VSAN 1 as a trunk

port.

[SwitchC-Vfc3] bind interface ten-gigabitethernet 1/0/3

[SwitchC-Vfc3] port trunk vsan 1

[SwitchC-Vfc3] quit

# Assign interface Ten-GigabitEthernet 1/0/3 to VLAN 10 as a trunk port.

[SwitchC] interface ten-gigabitethernet 1/0/3

[SwitchC-Ten-GigabitEthernet1/0/3] port link-type trunk

[SwitchC-Ten-GigabitEthernet1/0/3] port trunk permit vlan 10

[SwitchC-Ten-GigabitEthernet1/0/3] quit

# Enable FCoE for VLAN 10 and map VLAN 10 to VSAN 1.

[SwitchC] vlan 10

[SwitchC-vlan10] fcoe enable vsan 1

[SwitchC-vlan10] quit

# Permit the members in the default zone in VSAN 1 to access each other.

[SwitchC] vsan 1

[SwitchC-vsan1] zone default-zone permit

[SwitchC-vsan1] quit

4. Configure Switch D:

# Configure the switch to operate in advanced mode, save the configuration, and reboot the

switch. (Skip this step if the switch is operating in advanced mode.)

<SwitchD> system-view

[SwitchD] system-working-mode advance

Do you want to change the system working mode? [Y/N]:y

The system working mode is changed, please save the configuration and reboot the

system to make it effective.

# Configure the switch to operate in FCF mode, and enable the fabric configuration function in

VSAN 1. By default, the fabric configuration function is enabled.

<SwitchD> system-view

[SwitchD] fcoe-mode fcf

[SwitchD] vsan 1

[SwitchD-vsan1] domain configure enable

# Configure the domain ID as 14.

[SwitchD-vsan1] domain-id 14 preferred

Non-disruptive reconfiguration or isolating the switch may be performed. Continu

e? [Y/N]:y

[SwitchD-vsan1] quit

# Enable LLDP globally.

[SwitchD] lldp global enable

# Enable LLDP on interface Ten-GigabitEthernet 1/0/2, and enable the interface to advertise

DCBX TLVs.

[SwitchD] interface ten-gigabitethernet 1/0/2

[SwitchD-Ten-GigabitEthernet1/0/2] lldp enable