R211x-HP Flexfabric 11900 FCoE Configuration Guide

# Bind interface VFC 1 to interface Ten-GigabitEthernet 1/0/1, and assign it to VSAN 1 as a trunk

port.

[SwitchD-Vfc1] bind interface ten-gigabitethernet 1/0/1

[SwitchD-Vfc1] port trunk vsan 1

[SwitchD-Vfc1] quit

# Assign interface Ten-GigabitEthernet 1/0/1 to VLAN 10 as a trunk port.

[SwitchD] interface ten-gigabitethernet 1/0/1

[SwitchD-Ten-GigabitEthernet1/0/1] port link-type trunk

[SwitchD-Ten-GigabitEthernet1/0/1] port trunk permit vlan 10

[SwitchD-Ten-GigabitEthernet1/0/1] quit

# Create interface VFC 2, and configure it to operate in F mode.

[SwitchD] interface vfc 2

[SwitchD-Vfc2] fc mode f

# Bind interface VFC 2 to interface Ten-GigabitEthernet 1/0/2, and assign it to VSAN 1 as a trunk

port.

[SwitchD-Vfc2] bind interface ten-gigabitethernet 1/0/2

[SwitchD-Vfc2] port trunk vsan 1

[SwitchD-Vfc2] quit

# Assign interface Ten-GigabitEthernet 1/0/2 to VLAN 10 as a trunk port.

[SwitchD] interface ten-gigabitethernet 1/0/2

[SwitchD-Ten-GigabitEthernet1/0/2] port link-type trunk

[SwitchD-Ten-GigabitEthernet1/0/2] port trunk permit vlan 10

[SwitchD-Ten-GigabitEthernet1/0/2] quit

# Enable FCoE for VLAN 10 and map VLAN 10 to VSAN 1.

[SwitchD] vlan 10

[SwitchD-vlan10] fcoe enable vsan 1

[SwitchD-vlan10] quit

# Permit the members in the default zone in VSAN 1 to access each other.

[SwitchD] vsan 1

[SwitchD-vsan1] zone default-zone permit

[SwitchD-vsan1] quit

Verifying the configuration

1. Verify the configuration on Switch A:

# Display the domain information of VSAN 1.

[SwitchA] display fc domain vsan 1

Domain Information of VSAN 1:

Running time information:

State: Stable

Switch WWN: 48:33:43:2d:46:43:1A:1A

Fabric name: 48:33:43:2d:46:43:1B:1B

Priority: 128

Domain ID: 11

Configuration information:

Domain configure: Enabled