R211x-HP Flexfabric 11900 FCoE Configuration Guide

# Bind interface VFC 1 to interface Ten-GigabitEthernet 1/0/1, and assign it to VSAN 1 as a trunk

port.

[SwitchB-Vfc1] bind interface ten-gigabitethernet 1/0/1

[SwitchB-Vfc1] port trunk vsan 1

[SwitchB-Vfc1] quit

# Assign interface Ten-GigabitEthernet 1/0/1 to VLAN 10 as a trunk port.

[SwitchB] interface ten-gigabitethernet 1/0/1

[SwitchB-Ten-GigabitEthernet1/0/1] port link-type trunk

[SwitchB-Ten-GigabitEthernet1/0/1] port trunk permit vlan 10

[SwitchB-Ten-GigabitEthernet1/0/1] quit

# Create interface VFC 2, and configure it to operate in E mode.

[SwitchB] interface vfc 2

[SwitchB-Vfc2] fc mode e

# Bind interface VFC 2 to interface Ten-GigabitEthernet 1/0/2, and assign it to VSAN 1 as a trunk

port.

[SwitchB-Vfc2] bind interface ten-gigabitethernet 1/0/2

[SwitchB-Vfc2] port trunk vsan 1

[SwitchB-Vfc2] quit

# Assign interface Ten-GigabitEthernet 1/0/2 to VLAN 10 as a trunk port.

[SwitchB] interface ten-gigabitethernet 1/0/2

[SwitchB-Ten-GigabitEthernet1/0/2] port link-type trunk

[SwitchB-Ten-GigabitEthernet1/0/2] port trunk permit vlan 10

[SwitchB-Ten-GigabitEthernet1/0/2] quit

# Enable FCoE for VLAN 10 and map VLAN 10 to VSAN 1.

[SwitchB] vlan 10

[SwitchB-vlan10] fcoe enable vsan 1

[SwitchB-vlan10] quit

# Configure two static routes.

[SwitchB] vsan 1

[SwitchB-vsan1] fc route-static 010000 8 vfc 1

[SwitchB-vsan1] fc route-static 030000 8 vfc 2

[SwitchB-vsan1] quit

# Permit the members in the default zone in VSAN 1 to access each other.

[SwitchB] vsan 1

[SwitchB-vsan1] zone default-zone permit

[SwitchB-vsan1] quit

3. Configure Switch C:

# Configure the switch to operate in advanced mode, save the configuration, and reboot the

switch. (Skip this step if the switch is operating in advanced mode.)

<SwitchC> system-view

[SwitchC] system-working-mode advance

Do you want to change the system working mode? [Y/N]:y

The system working mode is changed, please save the configuration and reboot the

system to make it effective.

# Configure the switch to operate in FCF mode, and enable the fabric configuration function in

VSAN 1.