R211x-HP Flexfabric 11900 FCoE Configuration Guide

<SwitchC> system-view

[SwitchC] fcoe-mode fcf

[SwitchC] vsan 1

[SwitchC-vsan1] domain configure enable

# Configure the domain ID as 3.

[SwitchC-vsan1] domain-id 3 static

Non-disruptive reconfiguration or isolating the switch may be performed. Continu

e? [Y/N]:y

[SwitchC-vsan1] quit

# Create interface VFC 2, and configure it to operate in E mode.

[SwitchC] interface vfc 2

[SwitchC-Vfc2] fc mode e

# Bind interface VFC 2 to interface Ten-GigabitEthernet 1/0/2, and assign it to VSAN 1 as a trunk

port.

[SwitchC-Vfc2] bind interface ten-gigabitethernet 1/0/2

[SwitchC-Vfc2] port trunk vsan 1

[SwitchC-Vfc2] quit

# Assign interface Ten-GigabitEthernet 1/0/2 to VLAN 10 as a trunk port.

[SwitchC] interface ten-gigabitethernet 1/0/2

[SwitchC-Ten-GigabitEthernet1/0/2] port link-type trunk

[SwitchC-Ten-GigabitEthernet1/0/2] port trunk permit vlan 10

[SwitchC-Ten-GigabitEthernet1/0/2] quit

# Enable FCoE for VLAN 10 and map VLAN 10 to VSAN 1.

[SwitchC] vlan 10

[SwitchC-vlan10] fcoe enable vsan 1

[SwitchC-vlan10] quit

# Configure two static routes.

[SwitchC] vsan 1

[SwitchC-vsan1] fc route-static 010000 8 vfc 2

[SwitchC-vsan1] fc route-static 020000 8 vfc 2

[SwitchC-vsan1] quit

# Permit the members in the default zone in VSAN 1 to access each other.

[SwitchC] vsan 1

[SwitchC-vsan1] zone default-zone permit

[SwitchC-vsan1] quit

Verifying the configuration

# Display the FC routing table in VSAN 1 on Switch A.

[SwitchA] display fc routing-table vsan 1

Routing Table: VSAN 1

Destinations : 6 Routes : 6

Destination/mask Protocol Preference Cost Interface

0x020000/8 STATIC 10 0 Vfc1

0x030000/8 STATIC 10 0 Vfc1

0xfffc01/24 DIRECT 0 0 InLoop0

0xfffffa/24 DIRECT 0 0 InLoop0