R211x-HP Flexfabric 11900 Fundamentals Command Reference

155
startup saved-configuration
In standalone mode:
Use startup saved-configuration to specify a file as a next-startup configuration file for both active MPU
and standby MPU.
Use undo startup saved-configuration to configure the active MPU and the standby MPU to start up with
empty configuration at the next startup.
In IRF mode:
Use startup saved-configuration to specify a file as a next-startup configuration file for all MPUs in the IRF
fabric.
Use undo startup saved-configuration to configure all MPUs to start up with empty configuration at the
next startup.
Syntax
startup saved-configuration cfgfile [ backup | main ]
undo startup saved-configuration
Default
No configuration file is specified for the next startup.
Views
User view
Predefined user roles
network-admin
mdc-admin
Parameters
cfgfile: Specifies the name of a .cfg file. This .cfg file must already exist in the root directory of the flash
memory.
backup: Specifies the configuration file as the backup next-startup configuration file.
main: Specifies the configuration file as the main next-startup configuration file. This is the primary
configuration file that the device attempts to load at startup. If the loading attempt fails, the device tries
the backup next-startup configuration file.
Usage guidelines
CAUTION:
In an IRF fabric, use the undo startup saved-configuration command with caution. This command can
cause an IRF split after the IRF fabric or an IRF member reboots.
The startup saved-configuration command applies to all MPUs. To successfully configure the command,
verify that:
• In standalone mode, the specified file already exists in the root directory of the flash memory on
both active MPU and standby MPU.
• In IRF mode, the specified file already exists in the root directory of the flash memory on each MPU.