R211x-HP Flexfabric 11900 Fundamentals Command Reference

302
<Sysname> system-view
[Sysname] mdc Admin
[Sysname-mdc-1-Admin] undo location slot 3
The configuration associated with the specified slot of MDC will be lost. Conti
nue? [Y/N]:y
[Sysname-mdc-1-Admin]
quit
[Sysname] mdc sub1
[Sysname-mdc-2-sub1] location slot 3
# In IRF mode, authorize MDC sub1 to use the interface card in slot 3 on IRF member device 2.
<Sysname> system-view
[Sysname] mdc Admin
[Sysname-mdc-1-Admin] undo location chassis 2 slot 3
The configuration associated with the specified slot of MDC will be lost. Conti
nue? [Y/N]:y
[Sysname] mdc sub1
[Sysname-mdc-2-sub1] location chassis 2 slot 3
switchto mdc
Use switchto mdc to log in to a non-default MDC from the system view of the default MDC and enter
MDC system view.
Syntax
switchto mdc mdc-name
Views
System view
Predefined user roles
network-admin
network-operator
Parameters
mdc-name: Specifies the MDC name, a case-insensitive string of 1 to 15 characters. The MDC must have
been started.
Usage guidelines
You use this command to log in to only an MDC that is in active state.
Examples
# Log in to MDC sub1 from the system view of the default MDC.
<Sysname> system-view
[Sysname] switchto mdc sub1
******************************************************************************
* Copyright (c) 2010-2013 Hewlett-Packard Development Company, L.P. *
* Without the owner's prior written consent, *
* no decompiling or reverse-engineering shall be allowed. *
******************************************************************************
<Sysname>