R211x-HP Flexfabric 11900 Fundamentals Command Reference

40
Syntax
stopbits { 1 | 1.5 | 2 }
undo stopbits
Default
One stop bit is used.
Views
User line view
Predefined user roles
network-admin
mdc-admin
Parameters
1: Uses one stop bit.
1.5: Uses one and a half stop bits. The device does not support using one and a half stop bits. If you
specify this keyword, two stop bits are used.
2: Uses two stop bits.
Usage guidelines
This command is not supported in VTY line view.
The configuration terminal and the device must be configured to use the same number of stop bits to
communicate.
Examples
# Set the number of stop bits to 1 for user line AUX 1.
<Sysname> system-view
[Sysname] line aux 1
[Sysname-line-aux1] stopbits 1
telnet
Use telnet to Telnet to a host in an IPv4 network.
Syntax
telnet remote-host [ service-port ] [ vpn-instance vpn-instance-name ] [ source { interface interface-type
interface-number | ip ip-address } ] [ dscp dscp-value ]
Views
User view
Predefined user roles
network-admin
mdc-admin