R211x-HP Flexfabric 11900 Fundamentals Command Reference

Usage guidelines

To configure the same settings for all user lines of a line class, use this command to enter the user line

class view.

Some login management commands are available in both user line view and user line class view:

• A setting in user line view is applied only to the user line. A setting in user line class view is applied

to all user lines of the class.

• A non-default setting in either view takes precedence over a default setting in the other view. A

non-default setting in user line view takes precedence over a non-default setting in user line class

view.

• A setting in user line view takes effect immediately and affects the online user. A setting in user line

class view does not affect online users and takes effect only for users who log in after the

configuration is completed.

This command is an older version of the line class command. It is reserved for backward compatibility

purposes. Although it has the same function and output as the line class command, HP recommends that

you use the line class command.

Examples

# Set the user connection timeout to 15 minutes in VTY line class view.

<Sysname> system-view

[Sysname] user-interface class vty

[Sysname-line-class-vty] idle-timeout 15

# In AUX line class view, configure character s as the shortcut key for starting a terminal session.

<Sysname> system-view

[Sysname] line class aux

[Sysname-line-class-aux] activation-key s

[Sysname-line-class-aux] quit

# In AUX 1 line view, restore the default shortcut key for starting a terminal session.

[Sysname] line aux 1

[Sysname-line-aux1] undo activation-key

Alternatively:

[Sysname-line- aux1] activation-key 13

To verify the configuration:

1. Exit the console session.

[Sysname-line- aux1] return

<Sysname> quit

2. Log in again through the AUX line.

The following message appears:

Press ENTER to get started.

3. Press Enter.

Pressing Enter does not start a session.

4. Enter s.

A terminal session is started.