R211x-HP Flexfabric 11900 Fundamentals Configuration Guide

110
Ste
p
Command Remarks
2. Specify main or backup
startup images for the
standby MPU.
• Method 1:
boot-loader file ipe-filename slot
slot-number { backup | main }
• Method 2:
boot-loader file boot
boot-package system
system-package [ feature
feature-package&<1-30> ] slot
slot-number { backup | main }
• Method 3:
boot-loader update slot
slot-number
• Method 4: See "Enabling software
synchronization from the active
MPU to the standby MPU at
startup."
When you use method 3, make sure
you understand the following
requirements and upgrade results:
• If the active MPU started up with
main startup images, its main
startup images are synchronized to
the standby MPU. This
synchronization occurs regardless
of whether any change has
occurred to this set of startup
images.
• If the active MPU started up with
backup startup images, its backup
startup images are synchronized to
the standby MPU. This
synchronization occurs regardless
of whether any change has
occurred to this set of startup
images.
• Startup image synchronization will
fail if any software image being
synchronized is corrupted or is not
available.
3. Save the running
configuration.
save
This step makes sure any configuration
you have made can survive a reboot.
4. Reboot the device.
reboot
At startup, the MPUs read the
preloaded BootWare image to RAM
and load the startup images.
5. (Optional.) Verify the
software image
settings.
display boot-loader [ slot
slot-number ]
Verify that the current software images
are the same as the startup software
images.
Specifying the startup image file and completing
the upgrade (in IRF mode)
Perform this task in user view.