R211x-HP Flexfabric 11900 Fundamentals Configuration Guide

113
1. Copies the current software images of the active MPU.
2. Specifies them as startup software images.
3. Reboots with these images.
IMPORTANT:
To ensure a successful synchronization in a multi-user environment, prevent users from rebootin
g
or
swapping MPUs during the software synchronization process. You can configure the information center to
output the synchronization status to configuration terminals (see
Network Management and Monitoring
Configuration Guide
).
To enable software synchronization from the active MPU to the standby MPU at startup:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enable startup software
version check for the
standby MPU.
undo version check ignore
By default, startup software version
check is enabled.
3. Enable software
auto-update for the standby
MPU.
version auto-update enable
By default, software version
auto-update is enabled.
Displaying and maintaining software image
settings
Execute display commands in any view.
Task Command
Display current software images and startup
software images (in standalone mode).
display boot-loader [ slot slot-number ]
Display current software images and startup
software images (in IRF mode).
display boot-loader [ chassis chassis-number [ slot
slot-number ] ]
Software upgrade example (for standalone mode)
Network requirements
The device has two MPUs: one active MPU in slot 4 and one standby MPU in slot 5.
Use the file 119 0 0 . i p e to upgrade software images for the device.