R211x-HP Flexfabric 11900 Fundamentals Configuration Guide

ManualsBrandsHP ManualsNetwork HardwareHP FlexFabric 11000 Switch Products

191

192

193

194

195

196

197

198

199

200

189

[Device-mdc-2-MDCA] location slot 2

# Assign interfaces Ten-GigabitEthernet 2/0/1 through Ten-GigabitEthernet 2/0/48 to MDCA.

[Device-mdc-2-MDCA] allocate interface ten-gigabitethernet 2/0/1 to

ten-gigabitethernet 2/0/48

The configurations of the interfaces will be lost. Continue? [Y/N]:y

# Configure MDCA to use up to 40 percent of the total disk space on the MPUs in slot 4 and slot

[Device-mdc-2-MDCA] limit-resource disk slot 4 ratio 40

[Device-mdc-2-MDCA] limit-resource disk slot 5 ratio 40

# Start MDCA.

[Device-mdc-2-MDCA] mdc start

It will take some time to start MDC...

This MDC was started successfully.

[Device-mdc-2-MDCA] quit

# Log in to MDCA from the default MDC. Press Ctrl+D as prompted to access the CLI of MDCA.

[Device] switchto mdc MDCA

******************************************************************************

* Without the owner's prior written consent, *

* no decompiling or reverse-engineering shall be allowed. *

******************************************************************************

Automatic configuration is running, press CTRL_D to break or press CTRL_B to

switch back to the default MDC.

<Device> system-view

# Change the device name to MDCA for easy identification of the MDC.

[Device] sysname MDCA

# To enable the MDC administrator to remotely manage the MDC, assign an IP address to the

management Ethernet interface and enable the Telnet service.

[MDCA] interface M-GigabitEthernet 0/0/0

[MDCA-M-GigabitEthernet0/0/0] ip address 192.168.1.251 24

[MDCA-M-GigabitEthernet0/0/0] quit

[MDCA] telnet server enable

[MDCA] user-interface vty 0 63

[MDCA-line-vty0-63] authentication-mode none

[MDCA-line-vty0-63] user-role mdc-admin

# Return to the default MDC.

[MDCA-line-vty0-63] return

<MDCA> switchback

[Device]

2. Create and configure MDCB for Department B:

# Create MDCB.

[Device] mdc MDCB

Executing this command will create MDC MDCB ID 3 and empty folder /mdc/mdc3 in the

root directory of the storage media. Continue? [Y/N]:y

This MDC was created successfully

# Reclaim the interface card in slot 3 from the default MDC and assign it to MDCB.