R211x-HP Flexfabric 11900 High Availability Command Reference

55
Field Descri
p
tion
Valid packets received Number of the valid packets received.
Related commands
reset dldp statistics
dldp authentication-mode
Use dldp authentication-mode to configure DLDP authentication.
Use undo dldp authentication-mode to restore the default.
Syntax
dldp authentication-mode { md5 | none | simple }
undo dldp authentication-mode
Default
DLDP authentication is not performed.
Views
System view
Predefined user roles
network-admin
mdc-admin
Parameters
md5: Specifies the MD5 authentication mode.
none: Specifies not to perform authentication.
simple: Specifies the plain text authentication mode.
Usage guidelines
To enable DLDP to operate correctly, make sure the DLDP authentication modes and the passwords
configured on the two ends of a link are the same.
If you do not configure the authentication password after you configure the authentication mode, the
authentication mode is none no matter which authentication mode you configure.
Examples
# Configure to perform plain text authentication and set the password to abc (assuming that Device A
and Device B are connected by a DLDP link).
• Configure Device A:
<DeviceA> system-view
[DeviceA] dldp authentication-mode simple
[DeviceA] dldp authentication-password simple abc
• Configure Device B:
<DeviceB> system-view
[DeviceB] dldp authentication-mode simple
[DeviceB] dldp authentication-password simple abc