R211x-HP Flexfabric 11900 High Availability Command Reference

61
VRRP commands
The term "interface" in this chapter collectively refers to VLAN interfaces and Layer 3 Ethernet interfaces.
You can set an Ethernet port as a Layer 3 interface by using the port link-mode route command (see
Layer 2—LAN Switching Configuration Guide).
IPv4 VRRP commands
display vrrp
Use display vrrp to display the states of IPv4 VRRP groups.
Syntax
display vrrp [ interface interface-type interface-number [ vrid virtual-router-id ] ] [ verbose ]
Views
Any view
Predefined user roles
network-admin
network-operator
mdc-admin
mdc-operator
Parameters
interface interface-type interface-number: Specifies an interface by its type and number.
vrid virtual-router-id: Specifies an IPv4 VRRP group by its virtual router ID in the range of 1 to 255.
verbose: Displays detailed IPv4 VRRP group information. If the verbose keyword is not specified, this
command displays brief IPv4 VRRP group information.
Usage guidelines
• If no interface or VRRP group is specified, this command displays the states of all IPv4 VRRP groups.
• If only an interface is specified, this command displays the states of all IPv4 VRRP groups on the
specified interface.
• If both an interface and an IPv4 VRRP group are specified, this command displays the states of the
specified IPv4 VRRP group on the specified interface.
Examples
# Display brief information about all IPv4 VRRP groups on the device when VRRP operates in standard
mode.
<Sysname> display vrrp
IPv4 Virtual Router Information:
Running Mode : Standard
Total number of virtual routers : 1