R211x-HP Flexfabric 11900 IP Multicast Command Reference

126
network-operator
mdc-admin
mdc-operator
Parameters
vlan vlan-id: Specifies a VLAN. The value range for the vlan-id argument is 1 to 4094.
slot slot-number: Specifies a card by its slot number. If no card is specified, this command displays
information about the dynamic router ports on MPU. (In standalone mode.)
chassis chassis-number slot slot-number: Specifies a card on a member device. The chassis-number
argument specifies the IRF member device ID, and the slot-number argument specifies the number of the
slot where the card resides. If no member device is specified, this command displays information about
the dynamic router ports on all MPUs in the IRF fabric. (In IRF mode.)
Examples
# Display information about the dynamic router ports in VLAN 2.
<Sysname> display mld-snooping router-port vlan 2
VLAN 2:
Router slots (1 in total):
1
Router ports (2 in total):
XGE1/0/1 (00:01:30)
XGE1/0/2 (00:00:23)
Table 38 Command output
Field Descri
p
tion
VLAN 2 VLAN ID.
Router slots (1 in total)
Total number of cards where the dynamic router ports reside and the slot IDs of the
cards.
Router ports (2 in total) Total number of dynamic router ports and the port list.
Related commands
reset mld-snooping router-port
display mld-snooping static-group
Use display mld-snooping static-group to display information about static MLD snooping forwarding
entries.
Syntax
In standalone mode:
display mld-snooping
static-group [ ipv6-group-address | ipv6-source-address ] * [ vlan vlan-id ]
[ verbose ] [ slot slot-number ]
In IRF mode:
display mld-snooping
static-group [ ipv6-group-address | ipv6-source-address ] * [ vlan vlan-id ]
[ verbose ] [ chassis chassis-number slot slot-number ]