R211x-HP Flexfabric 11900 IP Multicast Command Reference

139
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] mld-snooping fast-leave vlan 2
Related commands
fast-leave (MLD-snooping view)
mld-snooping group-limit
Use mld-snooping group-limit to set the maximum number of IPv6 multicast groups that a port can join.
Use undo mld-snooping group-limit to restore the default.
Syntax
mld-snooping group-limit limit [ vlan vlan-list ]
undo mld-snooping group-limit [ vlan vlan-list ]
Default
The default setting is 4294967295.
Views
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
Predefined user roles
network-admin
mdc-admin
Parameters
limit: Sets the maximum number of multicast groups that a port can join, in the range of 0 to
4294967295.
vlan vlan-list: Specifies a space-separated list of up to 10 VLAN items. Each item specifies a VLAN by
its ID or a range of VLANs in the form of start-vlan-id to end-vlan-id. The VLAN ID is in the range of 1 to
4094. If this option is not specified, this command takes effect for all VLANs.
Usage guidelines
This command is effective on the IPv6 multicast groups that a port dynamically joins. If you configure the
port as a static member port for an IPv6 multicast group, this command is not effective on the IPv6
multicast group.
Examples
# Set the maximum number of IPv6 multicast groups that Ten-GigabitEthernet 1/0/1 in VLAN 2 can join
to 10.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] mld-snooping group-limit 10 vlan 2
mld-snooping group-policy
Use mld-snooping group-policy to configure an IPv6 multicast group filter on a port to control the IPv6
multicast groups that the hosts on the port can join.
Use undo mld-snooping group-policy to remove the IPv6 multicast group filter on a port.