R211x-HP Flexfabric 11900 IP Multicast Command Reference

142
undo mld-snooping last-listener-query-interval
Default
The default setting is 1 second.
Views
VLAN view
Predefined user roles
network-admin
mdc-admin
Parameters
interval: Sets the MLD last-listener query interval (in seconds), in the range of 1 to 5.
Usage guidelines
The MLD last-listener query interval determines the interval for sending MLD multicast-address-specific
queries and the maximum response delay for MLD multicast-address-specific queries in a VLAN.
You must enable MLD snooping for a VLAN before you configure this command for the VLAN.
The configuration made in VLAN view is only effective on the current VLAN and takes preference over the
global configuration.
Examples
# Enable MLD snooping for VLAN 2 and set the MLD last-listener query interval to 3 seconds.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping enable
[Sysname-vlan2] mld-snooping last-listener-query-interval 3
Related commands
• last-listener-query-interval (MLD-snooping view)
• mld-snooping enable
mld-snooping max-response-time
Use mld-snooping max-response-time to set the maximum response delay for MLD general queries in the
VLAN.
Use undo mld-snooping max-response-time to restore the default.
Syntax
mld-snooping max-response-time interval
undo mld-snooping max-response-time
Default
The default setting is 10 seconds.
Views
VLAN view