R211x-HP Flexfabric 11900 IP Multicast Command Reference

143
Predefined user roles
network-admin
mdc-admin
Parameters
interval: Sets the maximum response delay (in seconds) for MLD general queries, in the range of 1 to 25.
Usage guidelines
You must enable MLD snooping for a VLAN before you configure this command for the VLAN.
The configuration made in VLAN view is only effective on the current VLAN and takes preference over the
global configuration.
Examples
# Enable MLD snooping for VLAN 2 and set the maximum response delay for MLD general queries to 5
seconds.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] mld-snooping enable
[Sysname-vlan2] mld-snooping max-response-time 5
Related commands
• max-response-time (MLD-snooping view)
• mld-snooping enable
mld-snooping overflow-replace
Use mld-snooping overflow-replace to enable the IPv6 multicast group replacement function on a port.
Use undo mld-snooping overflow-replace to disable the multicast group replacement function on a port.
Syntax
mld-snooping overflow-replace [ vlan vlan-list ]
undo mld-snooping overflow-replace [ vlan vlan-list ]
Default
The IPv6 multicast group replacement function is disabled.
Views
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
Predefined user roles
network-admin
mdc-admin
Parameters
vlan vlan-list: Specifies a space-separated list of up to 10 VLAN items. Each item specifies a VLAN by
its ID or a range of VLANs in the form of start-vlan-id to end-vlan-id. The VLAN ID is in the range of 1 to
4094. If this option is not specified, this command takes effect for all VLANs.