R211x-HP Flexfabric 11900 IP Multicast Command Reference

144
Usage guidelines
This command is effective on the IPv6 multicast groups that a port dynamically joins. If you configure the
port as a static member port for an IPv6 multicast group, this command is not effective on the IPv6
multicast group.
The configuration made in proper interface view is only effective on the current port and takes preference
over the global configuration.
Examples
# Enable the IPv6 multicast group replacement function on Ten-GigabitEthernet 1/0/1 in VLAN 2.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] mld-snooping overflow-replace vlan 2
Related commands
overflow-replace (MLD-snooping view)
mld-snooping router-aging-time
Use mld-snooping router-aging-time to set the aging timer for the dynamic router ports in a VLAN.
Use undo mld-snooping router-aging-time to restore the default.
Syntax
mld-snooping router-aging-time interval
undo mld-snooping router-aging-time
Default
The default setting is 260 seconds.
Views
VLAN view
Predefined user roles
network-admin
mdc-admin
Parameters
interval: Sets an aging timer (in seconds) for the dynamic router ports in a VLAN, in the range of 1 to
1000.
Usage guidelines
You must enable MLD snooping for a VLAN before you configure this command for the VLAN.
The configuration made in VLAN view is only effective on the current VLAN and takes preference over the
global configuration.
Examples
# Enable MLD snooping for VLAN 2 and set the aging timer for the dynamic router ports in the VLAN to
100 seconds.
<Sysname> system-view
[Sysname] mld-snooping