R211x-HP Flexfabric 11900 IP Multicast Command Reference

174
Syntax
mld enable
undo mld enable
Default
MLD is disabled on all interfaces.
Views
Interface view
Predefined user roles
network-admin
mdc-admin
Usage guidelines
You must enable IPv6 multicast routing before executing this command in the public network or VPN
instance.
You must enable MLD on an interface to make MLD configurations on that interface take effect.
Examples
# Enable IPv6 multicast routing, and enable MLD for VLAN-interface 100 on the public network.
<Sysname> system-view
[Sysname] ipv6 multicast routing
[Sysname-mrib6] quit
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] mld enable
Related commands
ipv6 multicast routing
mld fast-leave
Use mld fast-leave to enable MLD fast-leave processing on an interface.
Use undo mld fast-leave to disable MLD fast-leave processing on an interface.
Syntax
mld fast-leave [ group-policy acl6-number ]
undo mld fast-leave
Default
MLD fast-leave processing is disabled. The MLD querier sends multicast-address-specific queries or
multicast-address-and-source-specific queries after receiving an MLD done message from a host, instead
of sending a leave notification directly to the upstream.
Views
Interface view
Predefined user roles
network-admin