R211x-HP Flexfabric 11900 IP Multicast Command Reference

213
Predefined user roles
network-admin
mdc-admin
Parameters
interval: Specifies a graft retry timer in the range of 1 to 65535 seconds.
Examples
# Set the graft retry timer to 80 seconds on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ipv6 pim timer graft-retry 80
ipv6 pim timer hello
Use ipv6 pim timer hello to set the interval for sending hello messages on an interface.
Use undo ipv6 pim timer hello to restore the default.
Syntax
ipv6 pim timer hello interval
undo ipv6 pim timer hello
Default
The hello interval is 30 seconds.
Views
Interface view
Predefined user roles
network-admin
mdc-admin
Parameters
interval: Sets the interval for sending hello messages, in the range of 0 to 18000 seconds. If the value for
this argument is 0, no hello messages are sent.
Usage guidelines
You can set the interval for sending hello messages in IPv6 PIM view or interface view. The configurations
made in IPv6 PIM view are effective on all interfaces, and the configurations made in interface view are
effective on only the current interface. If you set the interval in both IPv6 PIM view and interface view, the
configuration in interface view always takes precedence.
Examples
# Set the interval for sending hello messages to 40 seconds on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ipv6 pim timer hello 40
Related commands
timer hello (IPv6 PIM view)