R211x-HP Flexfabric 11900 IP Multicast Command Reference

222
Views
IPv6 PIM view
Predefined user roles
network-admin
mdc-admin
Parameters
time: Specifies a time that the device waits before receiving a new refresh message, in the range of 1 to
65535 seconds.
Examples
# On the public network, configure the device to wait 45 seconds before it receives a new state refresh
message.
<Sysname> system-view
[Sysname] ipv6 pim
[Sysname-pim6] state-refresh-rate-limit 45
Related commands
• ipv6 pim state-refresh-capable
• state-refresh-hoplimit (IPv6 PIM view)
• state-refresh-interval (IPv6 PIM view)
static-rp (IPv6 PIM view)
Use static-rp to configure a static RP.
Use undo static-rp to remove a static RP.
Syntax
static-rp ipv6-rp-address [ acl6-number | preferred ] *
undo static-rp ipv6-rp-address
Default
No static RP is configured.
Views
IPv6 PIM view
Predefined user roles
network-admin
mdc-admin
Parameters
ipv6-rp-address: Specifies the IPv6 address of the static RP. This address must be a valid IPv6 global
unicast address.
acl6-number: Specifies an IPv6 basic ACL number in the range of 2000 to 2999 to filter IPv6 multicast
groups. The C-RP is designated only to IPv6 multicast groups that pass the ACL filtering. If you do not
specify an ACL, or if you specify an ACL that does not exist or does not contain any valid rules, the static
RP is designated to all IPv6 multicast groups FF00::/8.