R211x-HP Flexfabric 11900 IP Multicast Command Reference

70
mdc-admin
Parameters
ip-address: Specifies the IP address of a C-BSR.
scope group-address: Specifies a multicast group address to which the C-BSR in an admin-scoped zone
is designated, in the range of 239.0.0.0 to 239.255.255.255. If this option is not specified, the C-BSR is
used for the global-scoped zone.
mask-length: Specifies the address mask length in the range of 8 to 32.
mask: Specifies the address mask.
hash-length hash-length: Specifies a hash mask length in the range of 0 to 32. The default setting is 30.
priority priority: Specifies a priority for the C-BSR, in the range of 0 to 255. The default setting is 64. A
larger value represents a higher priority.
Usage guidelines
The IP address of a C-BSR must be the IP address of a local PIM enabled interface on the C-BSR.
Otherwise, the configuration does not take effect.
If you execute this command for a zone multiple times, the most recent configuration takes effect.
You can configure the same C-BSR for different zones.
Examples
# Configure the interface with the IP address of 1.1.1.1 as the C-BSR for the global-scoped zone on the
public network.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] c-bsr 1.1.1.1
c-rp (PIM view)
Use c-rp to configure a candidate-RP (C-RP).
Use undo c-rp to remove the configuration of a C-RP.
Syntax
c-rp ip-address [ advertisement-interval adv-interval | group-policy acl-number | holdtime hold-time |
priority priority ] *
undo c-rp ip-address
Default
No C-RPs are configured.
Views
PIM view
Predefined user roles
network-admin
mdc-admin