R211x-HP Flexfabric 11900 IP Multicast Command Reference

Physical: Unknown

Last 300 seconds input rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec

Last 300 seconds output rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec

Input: 0 packets, 0 bytes, 0 drops

Output: 0 packets, 0 bytes, 0 drops

# Display brief information about Register-Tunnel 0.

<Sysname> display interface register-tunnel 0 brief

Brief information on interface(s) under route mode:

Link: ADM - administratively down; Stby - standby

Protocol: (s) - spoofing

Interface Link Protocol Main IP Description

REG0 DOWN -- --

# Display brief information about the Register-Tunnel 0 that is in down state.

<Sysname> display interface register-tunnel brief down

Brief information on interface(s) under route mode:

Link: ADM - administratively down; Stby - standby

Interface Link Cause

REG0 DOWN Not connected

Table 22 Command output

Field Descri

tion

Current state

Physical state of the register-tunnel interface. This field always displays

down.

Line protocol state Link state of the register-tunnel interface. This field always displays down.

Description Description of the register-tunnel interface. It is not configurable.

Bandwidth Expected bandwidth of the register-tunnel interface. It is not configurable.

Maximum Transmit Unit MTU of the register-tunnel interface. It is not configurable.

Internet protocol processing IP protocol processing capability. This field always displays disabled.

Physical

Physical type of the register-tunnel interface. This field always displays

Unknown.

Last 300 seconds input rate Average incoming rate in the last 300 seconds. This field always displays 0.

Last 300 seconds output rate Average outgoing rate in the last 300 seconds. This field always displays 0.

Input

Number of incoming packets, incoming bytes, and discarded packets. This

field always displays 0.

Output

Number of outgoing packets, outgoing bytes, and discarded packets. This

field always displays 0.

Brief information on interface(s)

under route mode

Brief information about Layer 3 interfaces.