R211x-HP Flexfabric 11900 IP Multicast Configuration Guide

141
• VOD streams are sent to receiver hosts in multicast. Receiver hosts of different organizations form
stub networks N1 and N2. Host A and Host C are multicast receiver hosts in N1 and N2,
respectively.
• MLDv1 runs between Switch A and N1, and between the other two switches (Switch B and Switch
C) and N2.
• Switch A acts as the MLD querier in N1. Switch B acts as the MLD querier in N2 because it has a
lower IPv6 address.
Configure the switches to meet the following requirements:
• The hosts in N1 can join only the IPv6 multicast group FF1E::101.
• The hosts in N2 can join any IPv6 multicast groups.
Figure 43 Network diagram
Configuration procedure
1. Assign an IPv6 address and prefix length to each interface according to Figure 43. (Details not
shown.)
2. Configure OSPFv3 between the switches to make sure the following conditions are met: (Details
not shown.)
{ The switches are interoperable at the network layer.
{ The switches can dynamically update their routing information.
3. Enable the IPv6 multicast routing, MLD, and IPv6 PIM-DM:
# On Switch A, enable IPv6 multicast routing.
<SwitchA> system-view
[SwitchA] ipv6 multicast routing
[SwitchA-mrib6] quit
# Enable MLD on VLAN-interface 100 (the interface that connects to the stub network).
[SwitchA] interface vlan-interface 100