R211x-HP Flexfabric 11900 IP Multicast Configuration Guide

157
• RFC 5059, Bootstrap Router (BSR) Mechanism for Protocol Independent Multicast (PIM)
• RFC 4607, Source-Specific Multicast for IP
• Draft-ietf-ssm-overview-05, An Overview of Source-Specific Multicast (SSM)
Configuring IPv6 PIM-DM
This section describes how to configure IPv6 PIM-DM.
IPv6 PIM-DM configuration task list
Task at a
g
lance
(Required.) Enabling PIM-SM
(Optional.) Enabling the state refresh feature
(Optional.) Configuring state refresh parameters
(Optional.) Configuring IPv6 PIM-DM graft retry timer
(Optional.) Configuring common IPv6 PIM features
Configuration prerequisites
Before you configure IPv6 PIM-DM, configure an IPv6 unicast routing protocol so that all devices in the
domain are interoperable at the network layer.
Enabling IPv6 PIM-DM
Enable IPv6 multicast routing before configuring IPv6 PIM.
With IPv6 PIM-DM enabled on interfaces, routers can establish IPv6 PIM neighbor relationship and
process IPv6 PIM messages from their IPv6 PIM neighbors. When you deploy an IPv6 PIM-DM domain,
HP recommends that you enable IPv6 PIM-DM on all non-border interfaces of routers.
IMPORTANT:
A
ll the interfaces on a device must operate in the same IPv6 PIM mode in the public network or the same
V
PN instance.
To enable IPv6 PIM-DM:
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Enable IPv6 multicast routing
and enter IPv6 MRIB view.
ipv6 multicast routing
[ vpn-instance vpn-instance-name ]
By default, IPv6 multicast routing is
disabled.
3. Return to system view.
quit
4. Enter interface view.
interface interface-type
interface-number
N/A