R211x-HP Flexfabric 11900 IP Multicast Configuration Guide

161
Configuring a static RP
If only one dynamic RP exists on a network, you can configure a static RP to avoid communication
interruption caused by single-point failures. The static RP also prevents frequent message exchange
between C-RPs and the BSR.
The static RP configuration must be the same on all routers in the IPv6 PIM-SM domain.
To configure a static RP:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter IPv6 PIM view.
ipv6 pim [ vpn-instance
vpn-instance-name ]
N/A
3. Configure a static RP for IPv6
PIM-SM.
static-rp ipv6-rp-address
[ acl6-number | preferred ] *
By default, no static RP is
configured.
Configuring a C-RP
In an IPv6 PIM-SM domain, if you want a router to become the RP, you can configure the router as a C-RP.
HP recommends that you configure C-RPs on backbone routers.
The C-RPs periodically send advertisement messages to the BSR, which collects RP set information. You
can configure the interval for sending the advertisement messages.
The holdtime option in C-RP advertisement messages defines the C-RP lifetime for the advertising C-RP.
The BSR starts a holdtime timer for a C-RP after the BSR receives an advertisement message. If the BSR
does not receive any advertisement message when the timer expires, it regards the C-RP failed or
unreachable.
To guard against C-RP spoofing, you must configure a filtering policy on the BSR to define the legal C-RP
address range and the multicast group range to which the C-RP is designated. In addition, because every
C-BSR might become the BSR, you must configure the same filtering policy on all C-BSRs in the IPv6
PIM-SM domain.
When you configure a C-RP, reserve a relatively large bandwidth between the C-RP and the other devices
in the IPv6 PIM-SM domain.
To configure a C-RP:
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Enter IPv6 PIM view.
ipv6 pim [ vpn-instance
vpn-instance-name ]
N/A
3. Configure a C-RP.
c-rp ipv6-address [ advertisement-interval
adv-interval | { group-policy acl6-number
| scope scope-id } | holdtime hold-time |
priority priority ] *
By default, no C-RP is
configured.
4. (Optional.) Configure a legal
C-RP address range and the
IPv6 multicast group range to
which the C-RP is designated.
crp-policy acl6-number
By default, no restrictions
are defined.