R211x-HP Flexfabric 11900 IP Multicast Configuration Guide

173
Figure 53 Network diagram
Table 11 Interface and IPv6 address assignment
Device Interface IPv6 address
Switch A VLAN-interface 100 1001::1/64
Switch A VLAN-interface 103 1002::1/64
Switch B VLAN-interface 200 2001::1/64
Switch B VLAN-interface 101 2002::1/64
Switch C VLAN-interface 200 2001::2/64
Switch C VLAN-interface 102 3001::1/64
Switch D VLAN-interface 300 4001::1/64
Switch D VLAN-interface 103 1002::2/64
Switch D VLAN-interface 101 2002::2/64
Switch D VLAN-interface 102 3001::2/64
Configuration procedure
1. Assign an IPv6 address and prefix length to each interface according to Figure 53. (Details not
shown.)
2. Configure OSPFv3 on the switches in the IPv6 PIM-DM domain to make sure the following
conditions are met: (Details not shown.)
{ The switches are interoperable at the network layer.
{ The switches can dynamically update their routing information.
3. Enable IPv6 multicast routing, MLD, and IPv6 PIM-DM:
# On Switch A, enable IPv6 multicast routing.