R211x-HP Flexfabric 11900 IP Multicast Configuration Guide

176

2: Vlan-interface102

Protocol: pim-dm, UpTime: 00:02:19, Expires: -

IPv6 PIM-SM non-scoped zone configuration example

Network requirements

As shown in Figure 54:

• VOD streams are sent to receiver hosts in multicast. The receivers of different subnets form stub

networks, and at least one receiver host exist in each stub network. The entire IPv6 PIM-SM domain

contains only one BSR.

• Host A and Host C are multicast receivers in the stub networks N1 and N2.

• VLAN-interface 105 on Switch D and VLAN-interface 102 on Switch E act as C-BSRs and C-RPs. The

C-BSR on Switch E has a higher priority. The C-RPs are designated to the IPv6 multicast group range

FF0E::101/64. Modify the hash mask length to map the IPv6 multicast group range to the two

C-RPs.

• MLDv1 runs between Switch A and N1, and between Switch B, Switch C, and N2.

Figure 54 Network diagram

Table 12 Interface and IPv6 address assignment

Device Interface

IPv6 address

Switch A VLAN-interface 100 1001::1/64

Switch A VLAN-interface 101 1002::1/64

Switch A VLAN-interface 102 1003::1/64

Ethernet

EthernetEthernet

N1N2

Vlan-

int101

Vlan-

101